Xh-m608 Manual ((better)) Official

Press SET while on a parameter to view its current value, then use ADD/DEC to change it. Long-press ADD/DEC for rapid adjustment. Range / Modes P0 Working Mode U

Main power input (6–40V DC) to power the module.

Relay stays closed only when the voltage is between the lower (P1) and upper (P2) limits. Xh-m608 Manual

The voltage at which the relay opens (turns off). 3. How to Program the Module

This is where the XH-M608 becomes a magician. Leave the jumper on: the relay coil and the logic circuit share the same 5V power – simple, for beginners. Press SET while on a parameter to view

Common programmable parameters (may vary slightly by firmware version):

Set P0 to your "recovery" voltage (e.g., 12.5V) and P1 to your "cutoff" voltage (e.g., 10.5V). Relay stays closed only when the voltage is

The manual emphasizes several safety precautions to ensure safe operation:

×