| Material | Nozzle Temp (Manual) | Actual Best Temp | Bed Temp | Enclosure | | :--- | :--- | :--- | :--- | :--- | | | 190-210°C | 205°C | 50°C | Door Open | | ABS | 230-240°C | 245°C | 100°C | Door Closed | | PETG | 220-235°C | 230°C | 70°C | Door Half Open | | Nylon | 250-260°C | 255°C | 100°C | Door Closed + Vent |
The manual suggests replacing the nozzle. Usually, the cause is different: The left heat sink fan is failing. Because the left extruder is used more often, its cooling fan weakens first. If the fan doesn't spin at 100%, heat creeps up and softens the filament. Replace the 24V 40x40x10mm fan. qidi x-pro manual
| Material | Nozzle Temp | Bed Temp | Fan Speed | Print Speed | |----------|-------------|----------|-----------|--------------| | PLA | 200–210°C | 50–60°C | 100% | 50–60 mm/s | | ABS | 230–240°C | 90–100°C | 0–20% | 40–50 mm/s | | PETG | 230–250°C | 70–80°C | 40–60% | 40 mm/s | | TPU | 220–230°C | 30–40°C | Off | 20–25 mm/s | | Material | Nozzle Temp (Manual) | Actual
Tighten or loosen the leveling knobs under the bed until you feel when pulling the paper. Repeat for all points at least twice to ensure stability. 🧵 Loading Filament If the fan doesn't spin at 100%, heat
The manual says "possible," but doesn't detail:
A: If you lost the USB drive, you can usually find the PDF on the official QIDI Tech website under the "Support" or "Download" section, or by contacting their support email directly.