Gordak 952 User Manual Updated |verified| -

| Task | Soldering Iron Temp | Hot Air Temp | Airflow | |------|--------------------|--------------|---------| | Through-hole desoldering | 350°C | 380°C | 60% | | SMD IC removal | N/A | 350–380°C | 50–70% | | Soldering small SMD parts | 320°C | 330°C | 40% | | Heat shrink tubing | N/A | 250°C | 30% |

: There are typically three red screws at the bottom of the machine. These secure the diaphragm pump during shipping. Operating the station without removing these will cause excessive noise, vibration, and eventual pump failure. Rework Station SS-952C-F Series - Farnell gordak 952 user manual updated

A beam of compressed air, shimmering with strange static, shot out from the rivet gun. It struck the empty space in the center of the room. | Task | Soldering Iron Temp | Hot

Before you even plug it in, there is one critical step most users miss. Remove the Transport Screws: Rework Station SS-952C-F Series - Farnell A beam

"Target acquired," the Gordak intoned. "The rivet will prevent the argument between Arthur and his wife at 6:04 PM regarding the dishwasher."

Apply a small amount of solder to the tip to prevent oxidation. 🛑 Safety & Maintenance

You must remove the two pump-securing screws (M5*10) located on the bottom of the unit before first use. Failure to do so can cause severe vibration or internal damage. Digital Interface: